Onkyo TX-SV343

Tuning in a radio station
<4 DOWN TUNING UP >
DIRECT TUNING
Number buttons
. Press either the FM or AM button on the main unit.
2. Change the frequency using the <4 DOWN or UP
TUNING button.
Press the «@ DOWN TUNING button to decrease the tre-
quency and press the UP TUNING button to increase
the frequency.
The TUNED indicator in the display lights up when the
station is properly tuned in.
In FM, each press of a TUNING button changes the fre-
quency in 100 or 50 kHz steps: in AM, the frequency
changes in steps of 9 or 10 kHz, depending on the area
where the unit is used.
a= DOWN TUNING
If a button 1s continuously held down for more than 0.5 sec-
onds while tuning an FM station, the frequencies are scanned
and tuning automatically stops when a broadcast 1s received.
!. Press either the FM or AM button on the main unit.
2. Press the DIRECT TUNING button.
*.. --” flashes in the display for 16 seconds.
3. While ‘“-- --’’ flashes, enter the frequency using the
number buttons.
For example, to enter “$8.10 MHz’, press the 8, 8, 1,
a.) ; then 0/10 number buttons.
L_—_
The
TUNED
indicator
in
the
display
lights
up
when
the
station 1s properly tuned in.
If you enter a frequency that is out of range, the frequency
display will flash and the unit will return to the previous fre-
quency.
DIRECT TUNING
U.S./Canadian and worldwide models (in 10 kHz step
made):
: ; ; Since the AM frequency changes in 10 kHz steps, any num-
a
ber
entered
in
the
|
kHz
digit
position
automatically
changes
Ody
cx to 0.
If you tune in a stereo FM station, the STEREO indicator
@
lights
up
if
the
signal
is
sufficiently
strong.
If
the
signal
is
weak, it may be impossible to tune in the station.
1. Press the FM MUTE/MODE button on the main unit.
FM MUTE MOE
The FM MUTE OFF indicator lights up. This changes
the broadcast to mono, so interstation noise can be heard.
2. Select the station that you want to listen to.
16