Onkyo TX-SV343

Connecting audio equipment
. Refer to the instruction manual of each component when making connections.
)\————(_” On each pair of connectors, the lower connector (red and marked R) corresponds to the right
channel and the upper connector (white and marked L) to the left channel.
Turntable
To wall outlet
CAUTION:
Do not plug in the power
cord until all connec-
tions have been made.
REAR SPEAKERS CENTER
R L SPEAKER
MANUFACTURED UNDER LCEMSE FROM DCR?
SABORA TORIES LICENSING CORPORATION
“DOLaT’ TRE DOUBLED SYMBOL AND “SAC LOG” Al
WIDEOIY VIDEO-2 MONITOR) | ARE "RADEMARES OF DOLBY LABORATORIES AEMOTE
| INPLIT 2 OITPUT INPUT ° QUTPLUT | | Sur LICENSING CORPORATION CONTROL
4 AC OUTLETS
ONEYO=s ! aC120¥ a0Hz
SHED
~
y : SWITCH
FRONT SPEAKERS AVG VIDED CONTRDL TOTAL 120W (4 MAX
CORPORATION |
FON SSeNCSCRE AGA Sh GsARL ”
i
RECEWER A
+A
-
-
Lb
+
MODELNO.
TX-S¥343
|
re
(en
HATING
|i
|
wa
|
NF
we
A
|
ae
aN
=
=|
OD
-
OOVOOOO
Er
_
+A - - i+
pHnwal J: i pretense ee seen
: CAUTION: SPEAKER IMPEDANCE
FRONT AOA BR: 6 OHMS MIN, / SPEAKER
FRONT A+G: 12 OHMS MIN.) SPEAKER
CENTER AERA: & OHMS MIN.) SPEAKER
CD player Tape deck
Cassette tape decks and a compact disc player that are
equipped with an Onkyo FRE connector can be operated
using the remote control included with this unit.
To enable remote control operation of other components,
connect the remote control cable as shown at the left.
TX-SV343
NOTE:
@ To enable proper remote control operation, both the RI
cables and the audio cables must be connected to the
units.
e This units remote contro! cannot be used to control
Onkyo turntables.
@ AnfRI remote control cable equipped with 1/8” (3.5 mm)
mini jacks ts included with any other component installed
with an fR# connector.
The direct function feature
When a compact disc player, and tape deck with the RI con-
nector are connected together, you can use the direct func-
tion feature.
Simply by directly operating the desired component (com-
pact disc player or tape deck), this unit's Input Selector auto-
matically switches to that component.
It is not necessary to switch this unit’s Input Selector when
changing listening sources.