Onkyo TX-SV343

Using preset radio stations
Number buttons
MEMORY FM MUTE MOGE
@
= CLEZ
)
1. Select the radio station frequency that you want to
store in the memory.
(Refer to Tuning in a radio station on page 16.)
2. Press the MEMORY button on the main unit.
The MEMORY indicator in the display lights up for 8
seconds.
3. While the MEMORY indicator is lit, continue press-
ing the GROUP button until the desired group is
selected.
With each press of the button, the group name that is
shown on the display changes one at a time in the follow-
ing sequence: A > B > C A...
4. Enter the desired preset number using the number
buttons.
Press the 0/10 number button when choosing preset num-
ber 10.
NOTE (European models only):
It the selected FM station broadcasts RDS signals with a PS
(Program service name), the name of the station is displayed
instead of the frequency. If there is no PS, the frequency is
displayed.
First. select the tuner as the source by pressing the AM or
FM input selector button on the main unit.
I. Press the GROUP button until the desired group is
displayed.
2. Enter the desired preset number using the number
buttons or press the SCAN button to scan through the
preset stations.
If the SCAN button is pressed, each station stored in the
selected group will be played for 5 seconds. When the
desired station is found, press the SCAN button again to
stop scanning.
Remote control operation
First, select the tuner as the source by pressing the TUNER
input selector button on the remote control.
1. Press the GROUP button until the desired group is
displayed.
2. Press the PRESET ( <4 or » ) button.
1. Select the station that you want to cancel.
(Refer to Selecting a preset station above. )
2. Hold down the MEMORY button on the main unit
and press the FM MUTE/MODE button.
*--"" appears in the display.
17