14
Tuning in a radio station
BALANCETREBLEBASS
SYSTEM
ON
OFF
SPEAKERS A
SPEAKERS B
PHONES
DOLBY SURROUND
PRO
•
LOGIC
AMFMTAPE(MONITOR)TV/AUX PHONO
/1VIDEO VDP
/2
VIDEO VCR
MAXMIN
AUDIO VIDEO CONTROL RECEIVER
TX-SV353
LR
C D
MASTER VOLUME
STAND-BY
123
456
789
GROUP 0/10 SCAN
MEMORY
FM MUTE / MODE
CLEAR
CENTER
MODE
SURROUND
MODE
DELAY TIME
TUNING DIRECT TUNINGDOWN UP
TUNINGDOWN UP
DIRECT TUNING
AM
FM MUTE / MODE
FM
Number buttons
1. Press either the FM or AM button on the main unit.
2. Change the frequency using the √√
√√
DOWN or UP ®®
®®
TUNING button.
Press the √ DOWN TUNING button to decrease the fre-
quency and press the ® UP TUNING button to increase
the frequency.
The TUNED indicator in the display lights up when the
station is properly tuned in.
In FM, each press of a TUNING button changes the fre-
quency in 100 or 50 kHz steps; in AM, the frequency
changes in steps of 9 or 10 kHz, depending on the area
where the unit is used.
If a button is continuously held down for more than 0.5 sec-
onds while tuning an FM station, the frequencies are scanned
and tuning automatically stops when a broadcast is received.
1. Press either the FM or AM button on the main unit.
2. Press the DIRECT TUNING button.
“-- --” flashes in the display for 16 seconds.
3. While “-- --” flashes, enter the frequency using the
number buttons.
For example, to enter “88.10 MHz”, press the 8, 8, 1,
then 0/10 number buttons.
The TUNED indicator in the display lights up when the
station is properly tuned in.
If you enter a frequency that is out of range, the frequency
display will flash and the unit will return to the previous fre-
quency.
Worldwide models (in 10 kHz step mode):
Since the AM frequency changes in 10 kHz steps, any num-
ber entered in the 1 kHz digit position automatically changes
to 0.
If you tune in a stereo FM station, the STEREO indicator
lights up if the signal is sufficiently strong. If the signal is
weak, it may be impossible to tune in the station.
1. Press the FM MUTE/MODE button on the main unit.
The FM MUTE OFF indicator lights up. This changes
the broadcast to mono, so interstation noise can be heard.
2. Select the station to which you want to listen.
Manual tuning
Direct tuning
Tuning in an FM stereo radio station
AMFM
TUNINGDOWN UP
AMFM
DIRECT TUNING
123
456
789
0/10
2
FM MUTE / MODE
1
1
3
2
To Next Page
Loading...
