Onkyo TX-SV353

21
Programming remote controller codes
Universal Programmable Remote Controller RC-383M
If you are using another manufacturer’s product that has a remote controller, you can memorize that component’s codes into the RC-383M.
NOTE:
• The commands of Onkyo cassette tape decks and the CD player are already stored at the DECK-A, DECK-B, and CD positions of the
remote controller.
• This remote controller uses infrared rays. Most remote controller codes can be memorized using the infrared system; however, depend-
ing on the degree to which the system differs, there may be some rare occasions when memorization is not possible.
Device commands
Symbol VDP VCR TV
POWER POWER POWER
PLAY PLAY –
STOP STOP –
– – CHANNEL UP, DOWN
– FAST REWIND –
– FAST FORWARD –
SENDING/LEARNED
indicator
SEND/LEARN
selector switch
PROGRAMMABLE
AREA
POWER
SLEEP
TV/AUX
VIDEO-1
VIDEO-2
TAPE PHONO C D
INPUT SELECTOR
TUNER
POWER
POWER
C H
SENDING/
LEARNED
LEARN
SEND
PROGRAMMABLE AREA TV/VIDEO
MULTI-CH
INPUT
1. SENDING/LEARNED indicator
This indicator acts as a guide when commands are pro-
grammed into or sent by the remote controller. It also
warns the user when an error is made or battery power is
low.
2. SEND/LEARN selector switch
SEND: Set the switch to this position when you are using
the remote controller. All buttons on the remote control-
ler can be used.
LEARN: Select LEARN to store another remote control-
ler’s signal code.
3. Programmable button area
See the table below.
Displays and switches
POWER
C H