16
Selecting a Surround mode
Since the TX-SV353 is equipped with a front amplifier, center amplifier, and a rear (surround) amplifier, all Dolby Pro Logic Surround
effects can be produced. When using video cassette tapes or video discs that have the DOLBY STEREO or DOLBY SURROUND trade
mark, you can enjoy the feeling of a movie theater in your own room. When reproducing these effects, placement of the rear (surround)
speakers is important for optimum sound quality in your room.
For best results with Dolby Pro Logic Surround, use the test tone to adjust the volume of all speakers to the same level.
Surround system
BALANCETREBLEBASS
SYSTEM
ON
OFF
SPEAKERS A
SPEAKERS B
PHONES
DOLBY SURROUND
PRO
•
LOGIC
AMFMTAPE(MONITOR)TV/AUX PHONO
/1VIDEO VDP
/2
VIDEO VCR
MAXMIN
AUDIO VIDEO CONTROL RECEIVER
TX-SV353
LR
C D
MASTER VOLUME
STAND-BY
123
456
789
GROUP 0/10 SCAN
MEMORY
FM MUTE / MODE
CLEAR
CENTER
MODE
SURROUND
MODE
DELAY TIME
TUNING DIRECT TUNINGDOWN UP
1 62
POWER
SLEEP
TV/AUX
VIDEO-1
VIDEO-2
TAPE PHONO C D
INPUT SELECTOR
C D
DISC
VOLUME
DECK-B
TUNER
POWER
POWER
C H
DECK-A
TUNER
PRESET
MUTING
LEVEL
REMOTE CONTROLLER
TEST
TONE
CH SEL
SENDING/
LEARNED
LEARN
SEND
GROUP
SUR
MODE
PROGRAMMABLE AREA TV/VIDEO
MULTI-CH
INPUT
RC-383M
4
3, 5
Before operating: Be sure to turn on
SPEAKERS A and turn off SPEAKERS
B when listening to Dolby Pro Logic Sur-
round.
1. Select a source encoded with Dolby
Surround and use the SURROUND
MODE button to select DOLBY PRO
LOGIC mode.
2. Use the CENTER MODE button to
select a center mode.
When the button is pressed, the mode
will change as shown below.
(Refer to page 17 for details of these
modes.)
3. Press the TEST TONE button on the
remote controller.
(Refer to Test Tone on page 17 for
details.)
4. From your listening position, use the
remote controller to adjust the rela-
tive volume level of the test tone from
the different speakers.
Adjust the volume levels of all of the
speakers with the VOLUME π (up)
and † (down) buttons.
Press the CH SEL button on the remote
controller until CENTER is selected
and use the LEVEL π or † button to
adjust the center speaker level to match
the front left and right speaker levels.
Then press the CH SEL button on the
remote controller to select REAR and
use the LEVEL π or † button to
adjust the levels of the rear speakers.
● If the center mode is set to PHANTOM,
only REAR can be selected by the CH
SEL buttons.
5. Press the TEST TONE button again
and stop the pink noise.
6. Use the DELAY TIME button to set
the delay time.
(Refer to page 18 for details.)
Adjusting the speaker
volumes before enjoying
Dolby Pro Logic Surround
SURROUND
MODE
C D
DISC
VOLUME
DECK-B
POWER
DECK-A
TUNER
PRESET
MUTING
LEVEL
TEST
TONE
CH SEL
GROUP
SUR
MODE
1
CENTER
MODE
2
TV/AUX
VIDEO-1
VIDEO-2
TAPE PHONO C D
To Next Page
Loading...
