3. Choose model
- In the port selection bar, please choose
the port you're using. For example: if you
use "COM1," choose COM1 in the port
selection.
- Click "Model" to choose the EDID le(*.ini)
and open it.
4. Programming
(1) Key in the serial number into the
barcode blank space.
(2) In"Write Source Select"item,select “VGA,
“HDMI 1” and “HDMI 2”.
(3) Check whether the port is the one
you're using.
(4) Click "Program" button.
5. When the message “Please change the
cable to VGA” is shown on the screen, click
“OK” button.
6. When the message “Please change the
cable to HDMI1” is shown on the screen,
click “OK” button.
(1)
(2)
(4)
(3)
To Next Page
Loading...
