Optoma HD86 - Powering Off the Projector

Delta Elec. Inc. HD86
Company Confidential Optoma___________________ Delta________________
59
2009/08/18
Powering Off the Projector
1. Press the “Power Off” button on the remote control or “POW-R” button on the rear of the
projector two times with one second interval in between to turn off the projector. First push
of button will display the following message on the screen.
Press the button again to confirm the shut down. If the button is not pressed,
the message will disappear in 5 seconds.
2. The cooling fans continue to operate for about 60 seconds for cooling cycle and the
Power LED will turn blue.
When the light is solid red, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has completed the
cooling cycle and has entered standby mode.
3. Disconnect the power cord from the electrical outlet and the projector.
4. Do not turn on the projector immediately following a power
off procedure