24
Cable Requirements
This following sections describe the Ethernet and IDN cable requirements for Oracle
MICROS workstations, printers, and remote display systems:
• Planning the Network introduces the concept of a structured cabling system and
provides MICROS recommendations and requirements for Ethernet and IDN
cabling.
• Installing the Ethernet Network describes how to run the cables and terminate
them at the wall plate.
• Installing an Integrated Device Network (IDN) describes the cabling options
available for driving MICROS IDN printers, including the use of a structured cable
system.
• Installing a Kitchen Display System describes the site requirements for
implementing a KDS and includes the MICROS wired (MBB) and wireless
(MWBB) bumpbars.
• Installing the e7 Kitchen Video Monitor (KVM) describes the cable requirements
for implementing a serial interface to the host workstation.
• Installing the Order Confirmation System describes the requirements for installing
the curb-side Pedestal including the concrete slab and conduit egress.
• Recommended Cables for a MICROS RS422 ION Network lists MICROS-
approved IDN cabling.
24-1
To Next Page
Loading...
