- 32 - - 33 -
5.2. Start MSCS
• MSCS is an application program needed to control MPDP.
• When you execute MSCS for your product at the installation screen, it will create a new folder
at
C:/Program File/MSCS
and an icon on your computer screen.
• By double clicking the MSCS icon, the initial screen image of MSCS will be displayed
as shown in the picture.
Main Image of MSCS (Multi Screen Control system)
5.3. Setting of COM Port
• Com Port connects or disconnects the communication between PC and MPDP.
• Connect MPDP to PC Com Port via RS-232C cable.
• Go to MSCS Menu -> Communication and set Com Port. Click 'Connect' using mouse or
press 'Ctrl+C' using keyboard.
• In order to disconnect communication, click 'Disconnect' using mouse or press 'Ctrl+D' using
keyboard.
When you use USB-to-RS-232C converters, you need to set Com Port again,
because MSCS uses one of Com Port no. 1 to 30.
※Available Com Port on the PC is automatically recognized and displayed.
• Com Port Configuration
Baud Rate 115200bps(Fixed)
Data Bit 8Bits
Parity None
Stop Bit 1Bit
Flow Control None
※To install MSCS, you need the account for the administrator.
※Check whether Windows Firewall or anti-virus program prohibits the
access of MSCS to the IP address of the display.
Caution
OPM-4260 | OPM-4260R
Innitely Expandable
To Next Page
Loading...
