How to assemble handles
• Install this set only at a location where adequate ventilation is available.
1. Product is packed in a box as shown in Figure 1.
2. Please carefully remove the Packing Bag with a knife or a pair of scissors.
※ Please check front and rear side before you cut the bag to prevent any damages
on panel or set.
3. Please assemble handles with the bolts that are in the accessory box to the
rear side as shown in the figure.
Handles
Packing Bag
[Figure 1]
[Figure 3]
[Figure 2]
[Figure 4]
Panel protection
How to move MPDP
1. 2 people hold each handle on product's back side.
2. It needs two people to carry or install this product.
Please hold the handles in the back and the front bottom part at the same time.
- Please do not grab the panel, but grab bottom of master frame when you carry or install the products.
- Please use gloves when you carry or install the products.
※ Attention :
- Do not remove the panel protection pad until a set is completely installed on a stand or a
wall hanger.
Please carefully remove Panel protection pad to prevent any damages on the product .
-Please make sure to use panel protection when you move, carry or rent MPDP.
Handles
Panel protection
Panel protection
OPM-4260 | OPM-4260R
Innitely Expandable
To Next Page
Loading...
