Orion OPM-4260 - MPDP System Setup and Cautions; Installation Environment and Serviceability

※Cautions for consisting MPDP System
Environmental condition for installation
- Since MPDP panel is very sensitive for physical impact, installation requires
considerable caution.
- Minimum clearance(20cm) must be secured for smooth ventilation. (See
P16~17)Installation must avoid air tight or near air tight places. Improper
ventilation causes malfunction and shortens product lifetime by rapid internal
temperature rise. If MPDP has to be installed at the improper ventilation,
additional ventilation openings or fans must be provided to keep the internal
temperature between 0 ~ 35˚C.
- For ground of MPDP and application devices, it should be connected as frame
ground.
- Considering MPDP Max power consumption, check the main electric
specication.
Consideration for easier service
- When you design the exterior design for MPDP system, consider easier
disassembly for possible service occasion in the future.
- The sliding Universal Unit of ORION is recommended for easier service.
- If service people can step into the backside of MPDP system, it can greatly
reduce time and effort for service.
- In case of higher locations, consider the installation location and exterior design
for easier service.
※ If the internal temperature reaches to 90˚C, "High Temperature" signal will be
displayed at the lower left corner on the screen for 1minute and the MPDPset
will be turned off automatically.
※ Please be noted that the lm lter on the front surface of the panel may lose its
color or change the color rapidly, if it is exposed to sunlight or ultraviolet rays.
The number of Daisy chain connection
- The image quality may vary depend on the quality of signal and cable condition.
INPUT SOURCE Resolution Connection Remark
DVI 1600 x 1200 x 60Hz 6 sets HDCP Available
PC 1600 x 1200 x 60Hz 3 sets
VIDEO NTSC, PAL, SECAM 6 sets
RS-232C 30 sets ORION Cable Only
- If you need to use more MPDP sets than indicated in the table, using a DVI
distributor is highly recommended.
Caution for the other control program besides MPDP
Control Program (MSCS)
- If you want to use automatic power on/off function that make MPDP turned on/
off by connecting main power, allow at least 20 seconds of Stand-by time before
MPDP is turned on, when you make control program.
- If RS-232C communication signal or other image signal is applied to 9 or more
sets simultaneously, communicational error may occur. (Power on & Broadcast)
- 4 - - 5 -
WARNING
WARNING
OPM-4260 | OPM-4260R
Innitely Expandable