Orion OPM-4260 - Afterimage Mitigation Feature; Status, Configuration, and Steps

- 42 - - 43 -
C. Configuration Step
1) Select PDP set for Afterimage Mitigation
Select ALL PDP or Broadcast for all PDP sets and One PDP for single PDP set.
2) Select the duration time in the Time Duration menu.
3) Select a pattern in the Mode menu.
4) Complete the configuration by pressing SET button. When you press SET button, following menu
window will be displayed. If you want to check the status of each PDP set, press the right button
of the mouse and press Check Status button.
5) Press Off button after configuration, Afterimage Mitigation pattern will be displayed for the
selected time and the PDP set will be turned off.
※ This function is for mitigating Afterimage. However, it does not prevent the occurrence of
Afterimage. Therefore, it is highly recommended not to display fixed image for long time.
Afterimage Mitigation Menu
A. Status
• It indicates the function of Afterimage Mitigation for each PDP.
B. Configuration
1) Time Duration: Decide the duration time for the display pattern.
2) Mode: Select a pattern for Afterimage Mitigation
• Full White: Display White on the entire screen.
• White Bar Scan: Display moving white bar pattern on the screen
• Default: No display
OPM-4260 | OPM-4260R
Innitely Expandable