1. Select one of “Manual & Event” or “Schedule & Event”.
2. In program configuration, set frame rate by 0 fps in “Normal mode” and only configure Event
frame rate.
3. Set Schedule.
Schedule configuration
Configure schedule for event recording and there are 2 modes – Always and Custom.
In “Always”, event works all the time and in “Custom”, works during configured time.
Configuration of schedule is similar with schedule configuration and can configure weekday, time for
Event.
• INDEX: Set from 1 to 50
• Weekday: Set weekday applicable
• Time: Set time applicable
• Deletion: Delete per INDEX
Configuration
Configured INDEX, weekday, time will be shown at once.
To Next Page
Loading...
