Schedule Setting
Set recording mode as “Schedule & Event” and set by date/ time.
Checking method for recording
<Reference>
If recording setting is finished correctly, “REC LED” in front is flickering. In addition, it is marked [S]
indicating that all channels are recording.
2.3 Connecting and configuring DIO ports
2.3.1 Wire Handling
When connecting a wire to a terminal block, follow the instruction below. Not the different types of wire
that can be used.
• Standard wire: Pie off the wiring cover 8~10mm and solder it. Wire gage should AWG
22~26.
• Sold wire: Peel off the wiring cover 8~10mm and solder it. Wire gage should be AWG
20~26
To Next Page
Loading...
