set with using [
◀
/
▶
] or [▲/▼]. Press [ESC] button when the value is set and also [ESC]
button is available to upper sub-menu.
2.2.1.1 Dialogue box to edit a word
Dialogue box to edit a word is image shown as below; it is available to input both word and bumper.
.
Keep pressing [▲/▼], [
◀
/
▶
] arrow button until the word is looking for and press Enter. In case of
deleting input word press [], spacing words press [] button. To exit from dialogue box, press [Enter]
after finishing word input.
2.2.2 Setting remote controller
2.2.2.1 Setting ID of DVR
When controlling several DVRs with one remote controller, set Remote Control ID as follows;
1. Press the [MENU] button
2. [
▶
] Select “system” with using [
▶
] arrow button and press [Enter] or [▼] button
3. [▼] Select “Utility” with using [
▶
] arrow button and press [Enter] button.
4. Select “Remote Control ID” and press [Enter]
5. [
◀
/
▶
] Select a value using [
◀
/
▶
] arrow buttons and press [ESC]
6. Press the [ESC] button to return to the monitor mode.
To Next Page
Loading...
