2.3.4.1 HDD registration and format
After mounting HDD and booting system, “Disk Manager” will execute automatically.
If not, please, check the connectivity of HDD.
1. Press [Enter] button in “Disk Manager”
2. Using [▲/▼] Key, select new HDD(Displayed [No] on Enabled item) and press [Enter]
3. If you see the message for format, select [Yes].
4. Press [ESC] and escape from “Disk Manager”
2.3.4.2 HDD Replacement
1. Turn off the DVR and take off the HDD that has a problem and replace it with new HDD.
2. Turn On the DVR and go to “Disk Manager” menu and select the previous HDD which has a
problem, and press “Enter” Key.
3. “Removed disk will be confirmed” message will be pop-up and select “Yes” to delete it from
the list.
4. Select the new HDD from the list and press “Enter” key.
5. Select “Yes” when the system asking “do you want to format”
6. After complete above procedure then Press “ESC” key to exit the “Disk Manager” menu.
<Note>
1. HDD Re-using (Add Used)
You can use HDD that has been used before from DVR, in this case you do not need to do
format and delete the data.
How to use it? Please install previous HDD in the DVR, and go to “Disk Manager” menu and
select the HDD that you wish to re-use which is you just installed HDD, and press “Enter”
To Next Page
Loading...
