2 Installation
2.1 Installation and Connection
2.1.1 Connecting & Running
2.1.1.1 Connecting camera
Connect CCTV camera to DVR with BNC cable as below
• The video type for all channels should be either NTSC or PAL, not be combined both
• DVR sets video signal’s impedance (75Ω) automatically. Impedance is set as 75 Ω basically.
If connecting a device to video output, impedance will be “Hi-z” status.
• Video Type (NTSC/PAL) should be changed after booting DVR. The order of camera
recognition follows ch1 through Ch16 camera and 1st recognized camera type leads other
camera type.
2.1.1.2 Connecting monitor
Connect CCTV monitor to DVR with BNC cable as below;
To Next Page
Loading...
