Orion OSD-400 - Disk Status

OSD-400/OSD-800/OSD-1600
Install & User Manual
-
Firmware 3.X
67
Bad Block
Display bad block. In HDD. If no problem, “0” will be displayed. Others are
Not shown anything at all.
Size
Display HDD size by MB unit
Enabled
Make HDD enable mode or disable mode.
Yes: enable / No: Disable
In case HDD YES
• Enabled: Press [Enter] in No mode or scroll mouse wheel. Notice window pops up and
show user the message like below.
• Caution: This Disk is not available without format. Will you format Disk?
• If selecting No, keep previous data and HDD will be Enable to use.
• If selecting Yes, delete previous data and HDD will be Enable to use.
In case HDD No
• Enabled: In Yes mode, press [Enter] or scroll mouse wheel and notice window pops up and
show user the message like below.
• Caution, will you remove Disk?
• If Yes, user will find the message “Disk is removed” on the bottom and Enable status will be
No.
• HDD is not used.
• If No, keep previous HDD without change.
6.2.2.2 Disk Status
Temperature and status of HDD will be shown.