Setting Sensor
1. Press [Menu] button and select “Event” when OSD menu is appeared.
2. Move to sub menu pressing [Enter] or using [▼] button and select [Enter]
All sensor
It is used when setting for all sensors and set off, or Normal Open (N.O.) / Normal Close (N.C.) type.
1. Select All and set type.
Each sensor
It is used when setting for each sensor and set selecting each sensor.
1. Select sensor and press [Enter] button.
2. Select sensor that user want set and set type
3. Press [ESC] after finishing value setting.
2.3.3.2 Connecting relay and setting
Specification
In order to run relay output of DVR normally, the following conditions are required.
SPEC
Output Ch. 2EA relay outputs
Output type Dry contact
Connecting type Connect the trimmed wire to terminal block
Performance
To Next Page
Loading...
