USE (SMTP-Auth)
If user selects Authentication in USE, SMTP-Auth function will work.
SMTP-Auth method is the way that E-mail will be authorized by SMTP server and then it will be
transmitted to receiver.
E-Mail Address
Input E-mail address of receiver.
Sender Address
Sender’s E-mail account should be SMTP authentication type.
For instance, If SMTP server address is xxx.test.com, e-mail address should be xxxx@test.com.
Authentication
Select USE (SMTP-AUTH).
SMTP Server
SMTP Server address should be available and its formation will be smtp.xxxx.com.
SMTP server address should be same with the SMTP server of Sender.
User ID
Input User ID authorized from SMTP Server.
Password
Input Password authorized from SMTP Server.
SMTP Port
Configure port number of SMTP in between 1~65535.
Including Picture
In general event, when sensor, MD, V-loss events are generated, the event information and channel
video will be sent to e-mail together.
But system event just send system event information.
NOT USE
This is the way of sending E-mail directly to receiver without SMTP server authentication
E-Mail Address
To Next Page
Loading...
