Note: If DHCP is disabled, the default static IP address of the SecureSync
unit is 10.10.201.x (x= dependent on ETH port).
2.9.1 Network connection (common tasks) :
Note: The SecureSync network settings have DHCP enabled by default.
Identify the IP address assigned to your SecureSync:
Since the SecureSync defaults to DHCP, when a unit is connected to a DHCP-enabled net-
work, an IP address should be assigned automatically. To identify the IP address and com-
municate with the SecureSync, follow one of the methods below.
On the front panel display:
The IP address is continuously displayed on the last line of the front panel (default setting).
More detailed network information can be found within the Netv4 sub-menu.
In the CLI:
The net, net4 or net6 commands will display the network settings for each Eth-
ernet port.
In the Web UI:
1.
Navigate to
MANAGEMENT > NETWORK > Network Setup.
2.
Click on the information icon next to an Ethernet port to view all network settings
for that port.
Disable or Enable DHCP
In order to assign a static IPaddress to an Ethernet port, it is necessary to disable DHCP.
On the front panel display:
1.
Press UP or DOWN on the keypad to enter the menu screen.
2.
Select the
Netv4 sub-menu and press the ENTERkey.
3.
Highlight the interface to be updated (
Eth0) and press the ENTER key.
4.
Select the
DHCP sub-menu and press the ENTER key.
5.
The State field will list the current DHCP status. Scroll through and select Disable in
the Action field and press the ENTERkey.
2.9 Network Setup
SecureSync Getting Started Guide Rev. 12.0 25
To Next Page
Loading...
Need help?
General
