● Balancer delta-to-balance: 15 mV
● Balancer enabled: True
● Balance only when charging: True
Other Parameters / Features:
These settings are consistent across all battery types. For capacity and protection settings, see the individual
sections below for your specific battery type.
● Number of cells: Leave this at the factory default setting that ships with the BMS.
○ 12V BMS: 4 cells
○ 24V BMS: 8 cells
● External switch: Set this to True if you have an external switch wired to the 2-pin connector, as
detailed in section 2.2.6.
● Load Detect: Enabled
● LED Enabled: N/A
● LED cap.: N/A
● NTC Settings: 12V BMS: The first two NTC’s should be enabled. The others are not present, so should
be disabled.
○ 24V BMS: The first 3 NTC’s should be enabled. The others are not present, so should be
disabled.
● BMS Name / PIN Protect: N/A; leave this setting to its default value
To Next Page
Loading...
Need help?
General
