5. Advanced User Guidebook
Follow-up and adjust the vertical and horizontal
settings.
Mode
Follow-up and adjust horizontal scale without changing
vertical setting.
Follow-up and adjust vertical scale without changing
horizontal setting.
Wave
Show Multi-period waveforms.
Only show one or two periods.
If you want to measure the two-channel signal, you can do as the follows:
1. Press Autoscale button, the function menu will appear.
2. Press H1 to choose ON.
3. Press H2 and choose for Mode item.
4. Press H3 and choose for Wave item.
Then the wave is displayed in the screen, shown as Fig.5-57.
Fig.5-57 Autoscale Horizontal- Vertical multi-period waveforms
Note:
1. Entering into Autoscale function and the
○
A flicker will be at the top left of the
screen. (flicker every 0.5 second)
2. In the mode of Autoscale, the oscilloscope can self-estimate “Trigger Type”
(Single, and Alternate) and “mode” (Edge, Video). At this point, the trigger menu
is not available.
3. At the mode of XY and STOP status, pressing Autoset to enter into Autoscale,
User Manual of Smart Digital Storage Oscilloscope
68
To Next Page
Loading...
