Need help?Do you have a question about the Packo RM/IB Series and is the answer not in the manual?
Emphasizes that only trained personnel should perform maintenance.
Outlines essential safety precautions related to electrical connections and usage.
Provides safety instructions for entering the tank and using cleaning agents.
Specifies that only recognized installers should perform installation.
Safety guidelines for lifting and moving closed tanks.
Provides specific guidelines for moving tanks with a built-in cooling unit.
Essential guidelines for placing the tank in the dairy, including environmental and access requirements.
Step-by-step instructions for installing the agitator on closed tanks.
Step-by-step instructions for installing the agitator on open tanks.
Step-by-step instructions for installing the agitator on VM/DX tanks.
Detailed steps for correctly leveling the milk cooling tank.
Guidelines for placing cooling units inside or outside with ventilation requirements.
Step-by-step guide for piping the remote cooling unit, including material and distance advice.
Safety warnings related to pipe fitting, welding, and handling of cooling agents.
Safety warning about exceeding maximum pressure and setting high-pressure pressostat.
Provides specific values for setting the low-pressure pressostat for different tank types.
Details basic values for setting the high-pressure pressostat based on unit type.
Explains settings for controlling fan motors based on ambient temperature and pressure.
Safety warning regarding maximum pressure and setting the high-pressure switch.
Explains the working principle of the DX cooling system phase by phase.
Explains the ice bank cooling process.
Describes the operational cycle of the cooling unit within the IB system.
Step-by-step procedure for filling the ice water reservoir.
Recommends differential cut-out and specifies earthing requirements.
Details the phased operation of the automatic cleaning system.
Warns against mixing cleaning agents due to poisonous gas risk.
Warns that manual cooling is for breakdowns and requires supervision.
Provides steps for manually cleaning the tank, including water and agent usage.
Describes the operation of the DIB cooling system stage by stage.
General| Material | Stainless steel |
|---|---|
| Stall Configuration | Rotary |
| Control System | Automated |
| Type | Rotary Milking Parlor |
| Number of Stalls | Varies (typically 20-80 stalls) |
| Power Supply | Electric (380-480V, 50/60Hz) |
To Next Page
