Deadman button of rope protection cylinder
Push the emergency cut-off button only in an emergency situation. To
resume work, unlock the button by pulling and turning it.
Running release / deadman button of crane interlock
Restart of radio remote control
In order to restart the radio remote control, press the emergency cut-off button and unlock it again.
Then press the start key of the radio remote control (N).
Wired remote control
In case of radio interferences and if radio remote control is disabled, it is possible to operate the unit
via wired remote control.
To do so connect the provided cable to the control stand and to the remote control handset. The key
switch for the preselection of operating modes must be in remote operation mode, then restart the
remote control.
During cable operation no radio signals are transmitted, because cable operation has a higher priority
than radio operation. The inserted battery gets charged automatically. During charging the emergency
cut-off on the handset may have been pressed, but the receiver must be switched on.
To Next Page
Loading...