Chapter 4 Device and function
charge status of the battery is automatically detected for the best charging procedure (quick
charging or trickle charging). After about 3 hours, the charging cycle is automatically shut off for
safety reasons.
Charge the battery completely.
Charger without battery - charger is supplied with
voltage.
Discharged battery put into charger - charging
procedure starts (approx. 3 hours).
Red LED illuminates, green LED flashes.
Battery fully charged and ready for operation.
Red and green LED's illuminate.
Red and green LED's illuminate.
Battery that has been inserted is defective and must be
replaced. Contact your PALFINGER partner.
Red LED illuminates, green LED off.
Information! Batteries must always be fully charged and
discharged, otherwise the service life of the batteries will be
considerably shorter.
Disconnect the charger when charging is completed.
Information! Only place fully charged batteries into the remote
control for remote control operation.
If the remote control is not in use for a longer time, remove the battery from the handset.
You may leave the charged battery in the switched on charger (red and green lights on), where it
remains fully charged (trickle charging). If the charger is off the battery will lose its full capacity.
Information! Properly handled batteries provide problem-free
remote control operation. The performance of the battery gradually
reduces during use.
Disposal:
EU countries: Dispose defective or used up batteries according to guideline 2006/66/EC.
All other countries: Observe local disposal regulations. Or dispose used up batteries at a public
collection point or specialized dealer. Do not throw them in household waste, fire or water.
Frequency switch
Press the start button twice in succession to switch the device to the next radio frequency - manual
synthesizer.
A short tone sounds and the red LED (4) briefly flashes once.
There are 12 frequencies programmed in the system. The system always starts with the original
frequency.
To Next Page
Loading...