Palm Tungsten Tungsten C User Manual

Conducting network HotSync operations
309
5. If your username does not appear, click New, enter your username, and
click OK.
6. Click OK again.
7. Perform one of the following:
– Put your handheld in the cradle/cable, and perform a HotSync operation.
The HotSync operation records network information about your computer
on your handheld. With this information, your handheld can locate your
computer when you perform a HotSync operation over the network. You are
ready to perform a network HotSync operation.
– Perform a wireless network HotSync operation. You will need to go through
a setup procedure on your handheld. See the next section “Performing a
wireless network HotSync operation”.
Performing a wireless network HotSync operation
After you prepare your computer and select your Conduit Setup options, you are
ready to perform a wireless network HotSync operation.
IMPORTANT
You must install the Palm Desktop software that came with your
Palm™ Tungsten™ C handheld before you attempt a network HotSync operation.
Your computer must have the software installed to communicate with your handheld.
IMPORTANT
Make sure your computer is on before performing a wireless HotSync
operation.
Performing a wireless HotSync operation
If you already performed a cradle/cable HotSync operation, you are ready for
network HotSync operation with no further preparation needed.

Palm Tungsten Tungsten C Specifications

General

Brand	Palm
Model	Tungsten Tungsten C
Category	Handhelds
Language	English