Palm Tungsten Tungsten C User Manual

Setting Communication Preferences
339
4. Press Function + Enter
,
or tap OK.
5. Press Function + Enter
,
or tap OK again to save the configuration.
After you create the configuration, you need to set up the HotSync Manager of
your Desktop application and the HotSync application of your handheld to
perform a modem HotSync operation.
Network preferences
CAUTION
Network preferences settings are for advanced users only. Changing your
Network preferences settings affects you handheld’s ability to operate in a wireless
environment. Use the Wi-Fi preferences settings to change your network settings.
See “Wi-Fi preferences” later in this chapter.
Your handheld supports 802.11b data connections and acts as a fully functional
data modem for circuit-switched connections over GSM.
Modem Accessory and TCP/IP software
Although your handheld is wirelessly enabled, you can also use TCP/IP software
that is included in the handheld operating system to connect with Internet service
providers (ISPs) or dial-in (remote-access) servers.
To use TCP/IP, you must create a configuration in the Connection Preferences
screen and then create Network Preferences settings.
The Connection Preferences screen enables you to define several ways that your
handheld can use a modem to communicate with remote devices. For example,
you can communicate with the service provider server, or with your computer if
you are traveling. See “Connection preferences” later in this chapter for a complete
explanation of how to create modem configurations.
After you configure both the Connection and Network preferences, you can
establish a PPP (Point-to-Point Protocol) connection with your service provider or
dial-in server. You can do this either by using menu commands from the Network
Preferences screen or by using a third-party application.
NOTE
TCP/IP enables you to connect to your service provider or dial-in server with
applications that allow you to view the transmitted data. Visit the web site
www.palm.com/support/globalsupport for information on third-party applications
that take advantage of TCP/IP.
Selecting a service
Use the Service setting to select the service template for your service provider or
for a dial-in server. Service templates are a set of service provider and dial-in server
configuration settings that you can create, save, and reuse. Also, you can create
new service templates. See “Creating additional service templates” later in this
chapter.

Palm Tungsten Tungsten C Specifications

General

Brand	Palm
Model	Tungsten Tungsten C
Category	Handhelds
Language	English