EasyManuals Logo

Palm Tungsten Tungsten C User Manual

Palm Tungsten Tungsten C
444 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #423 background imageLoading...
Page #423 background image
411
Product Regulatory and Safety Information
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC rules.
CAUTION
Changes or modifications not covered in this manual must be approved in writing by the
manufacturers Regulatory Engineering Department. Changes or modifications made without written
approval may void the users authority to operate this equipment.
In August 1996, the Federal Communications Commission (FCC) of the United States with its action
in Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio
frequency electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are
consistent with the safety standard previously set by both U.S. and international standards bodies.
The design of this product complies with the FCC guidelines and these international standards.
Exposure To Radio Frequency Energy (SAR)
In order to comply with FCC RF exposure safety guidelines, users MUST use a Palm brand body-
worn accessory during body-worn operation. Use of accessories not provided by Palm or that have
not been tested for RF exposure compliance with this product may not comply with the FCC RF
exposure safety guidelines and should not be used.

Table of Contents

Other manuals for Palm Tungsten Tungsten C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Palm Tungsten Tungsten C and is the answer not in the manual?

Palm Tungsten Tungsten C Specifications

General IconGeneral
BrandPalm
ModelTungsten Tungsten C
CategoryHandhelds
LanguageEnglish

Related product manuals