Palm Tungsten Tungsten C User Manual

Chapter 17 Performing HotSync
®
Operations
318
c. Click the Local tab.
d. In the Serial Port drop-down box, select the simulated port that your
computer uses for infrared communication.
See the documentation for your operating system for instructions on finding the
simulated port. This information is usually located in the Control Panel.
–Click OK.
NOTE
If your cradle/cable is connected to a USB port, you can continue using it while
HotSync Manager is configured for infrared communication. If your cradle/cable is
connected to a serial port, you cannot use your HotSync cradle/cable again until you
reconfigure the HotSync Manager to communicate with the port defined for cradle/
cable synchronization.
To configure HotSync Manager for infrared communication on a Mac computer:
1. Double-click the HotSync Manager icon in the Palm folder.
2. In the HotSync Controls tab, select Enabled.
3. Click the Connection Settings tab.
4. Select the On check box next to IR Port.
5. Close the HotSync Software Setup window.
Shown with
Mac OS X

Palm Tungsten Tungsten C Specifications

General

Brand	Palm
Model	Tungsten Tungsten C
Category	Handhelds
Language	English