Panasonic 2000

2000
- FIRE ALARM SOLUTIONS TECHNICAL DESCRIPTION
2
Table of Contents
1. INTRODUCTION 4
2. SAFETY INSTRUCTIONS 5
2.1. PERSONS 5
2.1.1. ORDINARY PERSON 5
2.1.2. INSTRUCTED PERSON 5
2.1.3. SKILLED PERSON 5
2.2. WARNINGS 6
3. GENERAL DESCRIPTION 7
3.1. OPTIONS 7
3.2. TOUCH SCREEN 9
3.3. ALARM PRESENTATION 9
3.4. CONTROL PANEL 9
3.5. USB 9
3.6. MAIN BOARD 10
3.7. CIE CHASSIS 11
3.8. BATTERIES 12
3.9. POWER SUPPLY 12
3.9.1. DISCONNECT DEVICE 13
4. CONNECTIONS IN THE CIE 14
4.1. INTERNAL CONNECTIONS 15
4.2. COM LOOP 15
4.2.1. EXAMPLE OF COM LOOP WIRING 16
4.3. PROGRAMMABLE VOLTAGE OUTPUTS (S1) 17
4.4. PROGRAMMABLE INPUTS (I1-I2) 17
4.4.1. USED AS GENERAL INPUT 17
4.5. RELAY OUTPUTS FOR ROUTING EQUIPMENT (TX) 18
4.5.1. FIRE ALARM OUTPUT 18
4.5.2. FAULT CONDITION OUTPUT 18
4.6. BALANCED INTERFACE FOR ROUTING EQUIPMENT 19
4.6.1. FIRE ALARM INTERFACE 19
4.6.2. FAULT CONDITION INTERFACE 19
4.7. POWER SUPPLY 24 V FOR GATEWAY 19
4.8. POWER SUPPLY OUTPUT 1 19
4.9. POWER SUPPLY OUTPUT 2 19
5. MOUNTING 20
5.1. WIRING 22
5.2. COMMISSIONING 22
6. INSTALLATION AND WIRING 24
6.1. WIRING OUTSIDE THE BUILDING 25
7. MAINTENANCE 26