Panasonic 2000

2000 - FIRE ALARM SOLUTIONS TECHNICAL DESCRIPTION
9
3.2. TOUCH SCREEN
The display is a colour touch screen.
Data:
• Display size: 7.0”
• TFT Screen LCD type
• Capacitive display
• Resolution: 1024 x 600 RGB
There are 12 status LEDs integrated in the display module:
Fire
System Fault
Fire brigade tx activated
Fault
Fire protection equipment activated
Disablement
Evacuation activated
Fire brigade tx delay
Alarm device
Fault/Disablement
Operation
Test Mode
Fire brigade tx
Fault/Disablement
In case of no re alarms, faults, disablements or test condition, the touch screen will go into sleep mode after 2 minutes.
3.3. ALARM PRESENTATION
In case of re alarms the re brigade personnel are able to see which alarm point/points having activated re alarm and to take
required operating control of the system.
The information displayed in the upper part is depending on how many alarm points having activated re alarm. In the middle part
will the re alarms be shown, one alarm point together with an user denable alarm text (if programmed).
3.4. CONTROL PANEL
The touch screen is also used for CIE operations such as commissioning, monthly test and maintenance. To get access to operate
the CIE, a user name and password is required. Up to ten user names can be used for three different user level types.
A password (six digits) for each user name is required.
See EBLOne Operating instructions for more information about status LEDs, alarm presentation and the control panel.
3.5. USB
The CIE is equipped with an USB interface (Type C), used for PC connection.