2000 - FIRE ALARM SOLUTIONS TECHNICAL DESCRIPTION
23
b) Connect the 24V supply cable to connector J1.
c) Connect the batteries (using the enclosed battery cables) to the main board, terminal block "J2".
When only one battery is used, connect both battery cables from plug-in connector J2 to the battery.
RISK OF EXPLOSION IF BATTERY IS REPLACED BY INCORRECT TYPE. DISPOSE USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
d) The CIE will do a restart, see chapter RESTART in Operating instructions.
e) If it is the very rst startup, select your language to be used in the control unit.
If Brittish language is selected, a pop-window will ask if you wish to change convention. Brittish convention is selected by
default.
If the information button is pressed before any language is selected, the service menu will be opened,
mainly intended for Production to test LEDs.
After 15 seconds of inactivity the screen will return to the Choose language page.
f) Put on the CIE cover on the chassis and x with the four screws.
The screws for the top and the bottom have dierent length.
1. Screw (M4 x 16 mm)
2. Screw (M4 x 12 mm)
g) You are now ready to congure the system. There is a wizard that will guide througth the conguration, see Operating instruc-
tions. If conguration is not needed, SSD can be created and downloaded with EBLWin.
To Next Page
Loading...
