Output format – Note regarding simultaneous output to the SDI OUT terminal and the HDMI terminal [X2]
243
To set how to turn on/off the LCD monitor and viewfinder
Sets the display method of the LCD monitor/viewfinder when [VIDEO OUT/LCD/VF] menu ¨ [VIDEO OUT SEL] ¨ [SDI + HDMI
OUTPUT] ¨ [ON].
1
Select [VIDEO OUT/LCD/VF] menu ¨ [VIDEO OUT SEL] ¨ [LCD/VF OUTPUT] ¨
[AUTO] or [LCD].
[AUTO]:
The LCD monitor is turned on when the LCD monitor is extracted. When you move your eye closer to the eye cup of the
viewfinder, the viewfinder is turned on.
[LCD]:
The LCD monitor is turned on when the LCD monitor is extracted. The viewfinder is not turned on.
To change the setting with a USER button
You can change how to turn on/off the LCD monitor and Viewfinder by registering [LCD/VF OUTPUT] to a USER button.
• For details about setting the USER button (ÎAssigning functions to the USER buttons: 65)
1
When the recording screen is displayed, press the USER button to which [LCD/VF
OUTPUT] is registered.
Switches the setting each time the button is pressed.
[AUTO] [LCD]
• The setting is also applied to the [VIDEO OUT/LCD/VF] menu ¨ [VIDEO OUT SEL] ¨ [LCD/VF OUTPUT] menu setting.
• There are the following limitations if [SDI + HDMI OUTPUT] is [ON]:
– [HDMI OUT FORMAT] cannot be set to [720×480p]/[720×576p].
– [SDI OUT FORMAT]/[HDMI OUT FORMAT] will have the same frame rate settings.
(Example) When [HDMI OUT FORMAT]/[SDI OUT FORMAT] is set to [1920×1080p]
If [HDMI OUT FORMAT] is set to [1920×1080i], then [SDI OUT FORMAT] will also be automatically set to [1920×1080i].
– Either one of the LCD monitor or the viewfinder only illuminates.
To Next Page
Loading...
