Panasonic AG-X2 - Page 322

Firmware Ver. 1.1 – USER Button Functionality Added
F-9
USER Button Functionality Added
The following functionality has been added for the USER buttons.
*1 In auto mode, the function cannot be used.
*2 When IR recording is enabled, the function cannot be used.
*3 In auto iris mode, the function cannot be used.
 One push auto iris function
In the manual iris mode, the USER button function [PUSH A.IRIS] enables use of the following functionality.
One push auto iris function:
By either pressing the USER button or touching the USER button icon, the mode switches to the auto iris mode and the iris (lens
stop) is automatically adjusted.
• The mode returns to the manual iris mode when the automatic adjustments finish.
Push auto iris function:
While the USER button is being pressed, or the USER button icon is being touched and held, the mode temporarily switches to
auto iris mode.
• When [AREA MODE] is set to [IRIS] or [FOCUS/IRIS] and the area function is used, the iris is automatically adjusted to suit
the subject that was touched.
• This is canceled when the USER button or USER button icon is released and the adjusted iris value is maintained.
Item (USER button icon display) Description
[LOW GAIN]
*1
([LOW GAIN])
Set [CAMERA] menu  [SW MODE]  [GAIN SETTING] to [PRESET MODE], then when you
either press the USER button or touch the USER button icon, the gain setting is switched to
LOW gain.
[MID GAIN]
*1
([MID GAIN])
Set [CAMERA] menu  [SW MODE]  [GAIN SETTING] to [PRESET MODE], then when you
either press the USER button or touch the USER button icon, the gain setting is switched to
MID gain.
[HIGH GAIN]
*1
([HIGH GAIN])
Set [CAMERA] menu  [SW MODE]  [GAIN SETTING] to [PRESET MODE], then when you
either press the USER button or touch the USER button icon, the gain setting is switched to
HIGH gain.
[W.BAL Ach]
*1, 2
([W.BAL Ach])
Either press the USER button or touch the USER button icon to switch the white balance
setting to “Ach”.
[W.BAL Bch]
*1, 2
([W.BAL Bch])
Either press the USER button or touch the USER button icon to switch the white balance
setting to “Bch”.
[W.BAL PRESET]
*1, 2
([W.BAL PRST])
Either press the USER button or touch the USER button icon to switch the white balance
setting to “Preset”.
[PUSH A.IRIS]
*2, 3
([PUSH A.IRIS])
Assigns the one push auto iris function.
• [STD] is displayed on the screen during auto iris mode.
• The one push auto iris function cannot be used in the following cases:
– In auto mode
– In auto iris mode
– In IR recording mode