– 137 –
Chapter 6 Menu Operations — Menu list
Item Description of settings
[SECONDARY DNS] Sets the secondary DNS server when [INFRA] is selected in [TYPE] and [DISABLE] is selected in [DHCP],
or when [ENABLE] is selected in [DHCP] and the primary DNS server cannot be obtained.
f Factory setting: [0.0.0.0]
[DHCP SERVER] Sets whether to use the DHCP SERVER function when [DIRECT] is selected in [TYPE] and the camera is
connected via wireless LAN.
[ENABLE]: Uses the DHCP SERVER function.
[DISABLE]: Does not use the DHCP SERVER function.
f Factory setting: [ENABLE]
[4G/LTE PROPERTY] [APN] Sets the APN (Access Point Name) provided by the provider.
[USER ID] Sets the user name provided by the provider.
[PASSWORD] Sets the password provided by the provider.
[DIAL NO.] Sets the phone number. For details, refer to the manual of the provider you have contracted.
[NETWORK TOOLS] [LOG DISPLAY] Displays the connection log.
[STATUS DISPLAY] Displays the network status.
[INITIALIZE] Restores the network setting status to the factory settings.
[PING] Checks network connection using PING commands.
[DISPLAY SETUP]
Congure the settings for the details to be displayed in the viewnder.
These menu items cannot be set when the thumbnail screen is displayed.
Item Description of settings
[ZEBRA1 DETECT] Sets the extraction level of zebra pattern 1.
[0%]…[109%]
f Factory setting: [70%]
[ZEBRA2 DETECT] Sets the extraction level of zebra pattern 2.
[0%]…[109%]
f Factory setting: [85%]
[ZEBRA2] Sets on/off of zebra pattern 2 and selects the type.
[ON], [SPOT], [OFF]
f Factory setting: [SPOT]
[CENTER MARK] Controls the center mark.
[1]: + (large)
[2]: Open center (large)
[3]: + (small)
[4]: Open center (small)
[OFF]: Does not display.
f Factory setting: [1]
[SAFETY MARK] Selects the type of frame for the safety zone marker.
[1]: Box
[2]: Corners
[OFF]: Does not display.
f Factory setting: [2]
[SAFETY AREA] Sets the size of the safety zone marker.
The constant ratio of length to width can be set in 1% increments.
[80%]…[100%]
f Factory setting: [90%]
[FRAME MARK] Enables/disables frame marker.
[ON], [OFF]
f Factory setting: [OFF]
[FRAME SIG] Sets frame marker aspect ratio.
[4:3], [13:9], [14:9], [1.85:1], [2.35:1]
f Factory setting: [4:3]
[FRAME LVL] Sets the level of the outside of the frame marker.
[0]…[15]
f Factory setting: [15]
[LEVEL GAUGE] Enables/disables level gauge.
[ON], [OFF]
f Factory setting: [OFF]
[FOCUS BAR] Displays/hides the focus bar indicating the degree of focus.
[ON], [OFF]
f Factory setting: [OFF]
[ZOOM/FOCUS] Switches the units of zoom and focus values when a serial lens is connected.
[NUMBER]: Displays position value of zoom from [000] to [999], and position value of focus from [0] to
[99].
[mm/feet]: Zoom is displayed in units of millimeters, and focus in units of feet.
[mm/m]: Zoom is displayed in units of millimeters, and focus in units of meters.
[OFF]: Neither zoom nor focus is displayed.
f Factory setting: [NUMBER]
[LEVEL METER] Displays/hides audio level meter.
[ON], [OFF]
f Factory setting: [ON]
To Next Page
Loading...
