– 27 –
Chapter 3 Preparation — Power supply
Power supply
A battery or external DC power supply can be used as the camera’s power supply.
Using batteries
Connection of the following batteries to the camera has been veried.
r Anton/Bauer batteries
HYTRON140
DIONIC HC
r IDX batteries
ENDURA10
r PAG batteries
PAG L96e
@@
NOTE
t Other batteries can be used by changing [BATTERY SELECT] using the main menu → [BATTERY SETUP]. Use of batteries that are already veried
as connectable to the camera is recommended.
t Before you use a battery, charge it with a battery charger. (For details on charging, refer to each operation instructions.)
Mounting and setting battery
Using Anton/Bauer batteries
Power supply output terminal for lighting
Anton/Bauer batteries
Light control switch
Release lever
1
Mount the Anton/Bauer battery.
2
Insert the battery terminal and slide in the direction of the arrow.
3
Set the battery type.
Select the type of battery from the main menu → [BATTERY SETUP] → [BATTERY SELECT].
For details, refer to “Setting menu basic operations” (page 119).
@@
NOTE
t The Anton/Bauer battery holder includes both a power supply output terminal for lighting and a light control switch, which are convenient when
installing light. Contact Anton/Bauer, Inc. for details on lighting systems.
t To remove the battery, keep the release lever of the battery holder completely down, slide the battery in the opposite direction of when you mounted it.
To Next Page
Loading...
