Panasonic AJ-PX800G - Adjusting the White and Black Balance

– 56 –
Chapter 4 Shooting — Adjusting the white and black balance
r Message displayed in the viewnder
Status Message Remark
During adjustment [ABB ACTIVE]
Adjustment completed [ABB OK]
f The adjusted value is automatically stored in
memory.
@@
NOTE
t During black balance adjustment, the aperture is set to automatically shut out light.
t During recording, black balance cannot be adjusted.
t During the automatic black balance execution, recording to the P2 card is not performed by pressing the <REC> button.
t The gain switching circuit is automatically switched during black balance adjustment. Flicker or noise sometimes appears on the viewnder screen.
This is not a malfunction.
Black balance memory
Values stored to memory are saved even if the camera is turned off.