Panasonic AJ-PX800G - Page 152

– 152 –
Chapter 7 SmartUI operation — SmartUI menu list
Corresponding button Setting details and setting value
<STOP> button
[D.CON]
Sets the aspect for the down-conversion output signal in the
HD mode. This item is not displayed in the SD mode.
[CROP]
Side-crop mode (Crops the left and right edges.)
[L.BOX]
Letterbox mode (Adds black bands at the top and bottom of
the image.)
[SQU]
Squeeze mode (Squeezes images horizontally.)
f Factory setting: [L.BOX]
[SET03:MON/HDMI SETUP]
Sets the output setting of the <MON OUT> terminal and <HDMI> terminal.
Corresponding button Setting details and setting value
<%/REW> button
[OUT]
Sets whether to output from the <MON OUT> terminal and the
<HDMI> terminal.
[ON], [OFF]
f Factory setting: [ON]
<STOP> button
[CHR]
Species whether characters are superimposed over the output
from <MON OUT>, <HDMI>, and <REMOTE> terminals.
[ON], [OFF]
f Factory setting: [ON]
This setting is disabled when the remote control unit (AJ-RC10G) or the extension control unit (AG-EC4G) is connected, and the
setting on the remote control unit or the extension control unit will be applied.
<FF/)> button
[ZBR]
Species whether the zebra pattern is superimposed over the
output from <MON OUT>, <HDMI>, and <REMOTE> terminals.
f This setting is not available when the setting menu on the
viewnder is open.
[ON], [OFF]
f Factory setting: [OFF]
[SET04:LCD]
Sets the display settings of SmartUI.
Corresponding button Setting details and setting value
<FF/)> button
[−]
Decreases the setting value of the selected item. Press and hold this button to continuously decrease the setting value.
<PLAY/PAUSE> button
[+]
Increases the setting value of the selected item. Press and hold this button to continuously increase the setting value.
<RESET> button
[RST]
Resets the setting value of the selected item to its factory setting value.
<MONITOR SEL> button
[→]
Moves the item selection to the right. When the item selection moves to the right edge, it moves back to the left edge.
[BACK LIGHT]
Sets the luminance of SmartUI.
[1]…[5]
f Factory setting: [3]
[CONTRAST]
Sets the contrast of SmartUI.
f The SmartUI screen may be hidden depending on the
setting value.
In such a case, press the <HOME> to return to the [HOME]
screen and hold down the <LIGHT> and <RESET> buttons.
The setting value of [CONTRAST] is reset to the factory
setting.
[0]…[63]
f Factory setting: [33]