– 172 –
Chapter 9 Connecting to External Devices — Connecting to the remote control unit (AJ-RC10G)
r Menu
[BLACK]
f 1st level: [RPED] [GPED] [BPED]
f 2nd level: [BLACK-VR-CONTROL]
f 3rd level: [BLACK-VR-MODE]
f 4th level: [BLACK-VR-RANGE]
[WHITE]
f 1st level: [RGAIN] [BGAIN]
f 4th level: [GAIN-VR-MODE]
f 5th level: [GAIN-VR-RANGE]
[KNEE] f 3rd level: [WCLIP] [WCLIPLVL]
[SHUTTER]
f 1st level: [MODE] [SPED] [ACTION]
The variable range of [SPED] when [FIX] is selected in [MODE] varies depending on the camera mode. Refer to
“Setting the electronic shutter” (page 57).
f [SYNCHRO SCAN DISP] is added in the second level. When [S.S] is selected in [MODE], select the unit of the value
to be displayed in [SPED] from either [SEC] or [DEG]. This change in the unit is also applied to the camera.
The variable range varies depending on the camera mode. Refer to “Setting the synchro scan mode” (page 58).
[FUNC] f 6th level: [RC-DATA-SAVE]
[SYSTEM]
f 1st level: [CARD-READ] [TITLE]
f 2nd level: [CARD-WRITE] [TITLE]
f 3rd level: [CARD-DELETE] [TITLE]
f 4th level: [CARD-CONFIG]
f 5th level: [BUZZER]
f 6th level: [LCD CONTRAST]
f 7th level: [SW BRIGHT]
f 8th level: [RCU-FACTORY]
f 9th level: [VERSION]
r <SHAD> lamp, <FLARE> lamp, <MATRIX> lamp, <GAMMA> lamp, <DTL> lamp, <SKIN DTL> lamp, <KNEE> lamp
When connected to the camera, AJ-RC10G menu operations are disabled even if these lamps are illuminated.
r <BLACK> volume
Works only as volume adjustment for the pedestal ([PED]).
However, this does not work when [FLR] (are) is selected in [BLACK-VR-CONTROL] in the AJ-RC10G menu.
Also, when automatic black balancing (ABB) is performed, the <VR ACTIVE> button light goes off and the <BLACK> volume setting value is cleared to
0.
@@
NOTE
t The status adjusted with AJ-RC10G connected will always be recorded on the camera. The setting of [FUNC] → [RC-DATA-SAVE] in the AJ-RC10G
menu is currently disabled.
t When connecting or removing a dedicated cable, be sure to set the <POWER> switch of the camera and AJ-RC10G to <OFF>.
t Use a cable or optional cable that is dedicated for AJ-RC10G. Otherwise, a malfunction may result.
t The USER buttons on the camera (<USER MAIN>/<USER1>/<USER2>) and <MENU> button do not function when AJ-RC10G is connected.
t For details on the current from the <REMOTE> terminal, refer to “Details of the connector signals” (page 215).
t For the software version of AJ-RC10G, use Ver.1.20 or higher.
For the updated versions of AJ-RC10G software, refer to the support information for P2 in the following website.
http://pro-av.panasonic.net/
To Next Page
Loading...
