Panasonic AlCare TK-AS500 - Using water when signal lights up

EN27
4
When the water quality signal lights up,
use water.
PiPiPi
z At the beginning of daily use, run water
approx. 0.6 liters (approx. 18 seconds)
before using. (P. EN7)
z Preparation time may become longer
such as when water quality is switched
during water ow, after acidic water
is used, and when puried water
or alkaline ion water is used after
automatic electrode cleaning.
z The color of water quality signal
changes according to the type of
selected water.
y Alkaline 1–3 : Blue
y Puried water : Green
y Acidic water : Pink
5
After use,
close the faucet.
z When using the product continuously
For 10 minutes after Alkaline 1 to 3 or puried
water is used, the same type of water can be used
with short preparation time. (Water comes out
from the drain hose after 10 minutes.)
z After Alkaline 1 to 3 or puried water is used,
the selected water type is stored until next use.
(To change the setting → P. EN32)
If water types other than those are used,
the product is restored to the state where
Alkaline 1 to 3 is selected previously.
z Water may come out slightly from the main
spout even after the water ow is stopped. It
is not a malfunction. (This is water remaining
in the outlet pipe.)

When the water quality signal turns
o󰀨 while water is owing
When the faucet is not su󰀩ciently opened or
the amount of water ow is decreased due to
change in water pressure, the water quality
signal turns o󰀨. (For alkaline water and acidic
water, electrolysis is stopped.)
When the water quality signal is turned o󰀨,
open the faucet again, and adjust the amount
of water ow.
z Do not drink water while the water quality
signal is blinking.

When a buzzer beeps for approx. 3
seconds, and
lights up
(P. EN31)

When a buzzer beeps continuously
While acidic water is used, a warning buzzer
beeps continuously. (To prevent accidental
swallowing)
z
To pause the buzzer sound: press
z To make the setting with no buzzer (P. EN32)

When blinks
(Only when alkaline ion water or
acidic water is in use)
This is displayed when a large amount of water is owing.
( In this case, it may not be possible to achieve a su󰀩cient
pH level.)
z Gradually reduce the ow from the faucet until
the indicator turns o󰀨*.
* Alkaline 1–3 : Flow of about 4.5 L/minute
Acidic water : Flow of about 2.3 L/minute
How to Use
English