When the
indicator
is lit
Automatic electrode cleaning is performed to remove
calcium deposited on the electrode plate.
Wait for a while.
z Do not remove the power plug.
z
Water coming out of the main spout and drain hose during automatic electrode
cleaning cannot be used. (The water has been used during cleaning.)
z The electrode plate is located in the electrolyzer inside the main unit.
Removing the calcium prevents deterioration of electrolysis capability.
Start timing of automatic electrode cleaning
After every use of
alkaline ion water
After every
use of acidic
water
When the Alkaline Ionizer has not been
used for 24 hours
When the faucet
is turned o
When water is owed after
selecting alkaline ion water or
puried water...
Automatic Electrode Cleaning
(Approx. 8 seconds)
“-----” is displayed.
Automatic Electrode Cleaning
(Approx. 10 seconds)
“-----” is displayed.
Water comes
out from the
drain hose
Remains lit
(until completion
of cleaning)
From main
spout and
drain hose
Buzzer beeps
from the start
(about 3
seconds)
Remains lit
(until completion
of cleaning)
Water quality
signal
Cleaning : Blinks in pink
Preparation : Blinks in blue
or green
Cleaning complete :
Lit in blue or
green
z
When water is stopped during preparation (while
the water quality indicator is blinking), the automatic
electrode cleaning is not performed.
z
Do not run water until the cleaning is completed.
z
Even if turns o, water may come out
from the drain hose.
z
Water may drip from the main spout. It is not a
malfunction. (This is water remaining in the outlet pipe.)
z
The automatic electrode cleaning is not performed for
10 minutes after alkaline ion water 1 to 3 is used.
The water quality signal blinks in pink during
automatic electrode cleaning. After the cleaning
is completed, the water quality signal changes to
blue or green.
When a buzzer beeps, you can use the product.
z
Do not stop water ow until the cleaning is completed.
Automatic Electrode Cleaning
EN31
Maintenance and
replacement
English
To Next Page
Loading...
