Bypass selector mounting part
Remove the bypass selector, then rinse
the lter and water intake.
z The water ow may decrease when the
lter in the bypass selector connection
area becomes clogged with impurities.
Important
z
Do not use detergents, cleansers, paint thinners, benzine, alcohol or kerosene for cleaning purposes. If, for instance,
a detergent is used by mistake, wipe the surface with a damp cloth immediately to remove all traces of the detergent.
( Otherwise, the detergent may get mixed in with the water running through the Alkaline Ionizer, the plated parts may
be damaged or peel o, or the plastic parts may become damaged, discolored or deformed.)
y Use of cleansers may also impair the workings of the outlet pipe and cause trouble.
z Do not use brushes or other implements made of metal (since they may leave scratch marks).
z Do not use a tool to tighten up the nut (since the nut may be damaged).
Set the bypass selector to“ ”.
2Loosen the nut, remove the bypass
selector, and take out the gasket and lter.
Gasket
Nut
Filter
Be sure to follow this order.
Reinstall
2Securely tighten the nut.
3After mounting the bypass selector,
set the lever to
“
” and
allow water to
flow for about
5 seconds.
Ensure to
install
(No front or
back)
Tighten
rmly by
hand
Remove
the stain using
a clean cotton
swab, etc.
Bypass
selector
Main
spout
Remove the
dirt using a
clean toothbrush
or other similar
tool.
At least once a
week
Once a year
Main unit, bypass selector and outlet pipe
Soak a soft cloth in water, wring it out well,
and use it to wipe the units and parts.
Maintenance
Filter
Water intake
Using a
clean toothbrush
or similar
tools
How to attach
How to remove
EN28
To Next Page
Loading...
