1
Disconnect the power plug,
and remove the cap.
Remove the cover
Hold the knob, turn it, and pull it out
.
Knob
Cap
Cover
Extrude it
2
Turn the main unit upside down, and
drain o the inside water.
3
Disconnect the water supply hose.
Water supply hose
Hose
fastening
nut
Loosen
with hand
z
After disconnecting the water supply hose, attach the hose
fastening nut to the original position of the bypass selector
(loss prevention).
4
Stand the main unit,
and remove the cartridge. (P. EN30)
z
When the cartridge is removed or is in the removed state, do not
face the main spout up, or tip over or reverse the main unit.
(Water may enter the inside the main unit, resulting in a
malfunction.)
5
Put the tip of the water supply hose at
a position lower than the main unit,
and discharge the water
remaining in the hose.
Water supply hose
Suction Disc
6
Remove the suction disc xing
the drain hose, and attach the
cartridge and the cover to the
original position.
(P. EN30)
7
Loosen the nut,
remove the bypass selector,
and remove the water inside.
Loosen
with hand
When the joint is dicult to remove
After tightening the nut rmly with
hand, rotate it together with the bypass
selector. Then it can be removed easily.
z If it still cannot be removed, use a tool
such as a plier to nip the adaptor, and
remove it.
z When using a tool such as a plier, protect
the joint with cloth, etc. not to damage it,
and pay attention to the rotation direction.
Adaptor
Remove water from the main unit with the following steps before moving the product.
z Stand the main unit while moving. After removing the water, a small amount of water may remain, so put the
main unit in a bag, etc.
When Moving the Alkaline Ionizer
EN34
To Next Page
Loading...
