EasyManua.ls Logo

Panasonic AlCare TK-AS500 - Operating Precautions; Water supply considerations; Installation precautions; Usage guidelines

Panasonic AlCare TK-AS500
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN9
Operating Precautions
Water supply
z Do not drink water in case of the following
conditions.
y Very turbid water, or water containing a great
deal of red rust
( Doing so may shorten the service life of the
cartridge.)
y Well water near sea coast
(Doing so may cause malfunction.)
z When using the product in areas where
the hardness of tap water is high*,
discharge acidic water for about 1 minute
before using every day.
( Otherwise, the calcium will attach in the main
spout and the passage of water, resulting in poor
water run.)
* In areas where the hardness of water is high,
soaps poorly lather up, and white matter
(calcium) will attach to teapots and pots.
z
Depending on the quality of tap water in the
residential area, the pH level of the water
may not be adjusted to the specied level.
Installation
z Do not install the Alkaline Ionizer in the
following locations.
y Near hot areas such as heating appliances
(60 °C or above)
(The product may become deformed.)
y Where the product is exposed to direct
sunlight, or wind and rain
(An operational error or malfunction may occur.)
y Where freezing may occur
(Cracking in the water pipes or cartridge may occur.)
y Where the product tends to be subject to oil
(The main unit may be cracked.)
y In a bathroom or where the product is
exposed to water or steam
(An operational error or malfunction may occur.)
y
In areas lower than the kitchen counter (such as the oor)
(Water may not be drained completely.)
y Near radios
(Radio wave interference or noise may occur.)
z Do not connect the Alkaline Ionizer to a
hot water-dedicated faucet.
(Doing so may cause malfunction.)
z Do not extend the main spout using a
commercially sold hose, etc.
(Doing so may cause malfunction.)
Usage
z
Do not lay down the main unit for use.
(Doing so may cause malfunction.)
z Use water with the temperatures shown in
the table below.
( Failure to do so may cause damage, or cause trihalomethane
adsorbed by the cartridge to be partially discharged.)
Position of bypass selector
Water
temperature
When using alkaline ion water, etc.
: Puried
Under 35 °C
When using tap water
:
Unpuried (Straight)
Under 80 °C
:
Unpuried (Shower)
z
Do not continuously use alkaline ion water
and acidic water for approx. 10 minutes or
more.
( Using such water approx. 10 minutes or more
displays U27, and stops electrolysis.→P.EN35)
Handling of pH test liquid (P. EN13, EN22)
z Store the pH test liquid in a place
without direct sunlight.
( Discoloration of the liquid may result in
incorrect measurement)
z To dispose of the pH test liquid, dilute
it with water and discharge it into
sewage.
Conrmation
English

Related product manuals