EN18
1
Choose a stable,
level surface.
9.5 cm
or more
17 cm or more
2
Extend the power cord and hose in the manner
that best suits the location where the unit is installed.
z Do not atten or bend the cord or hose.
Wedge the hoses
into this cutout
Water supply hose
Power cord
Condensation water
outlet (P. EN40)
Drain hose
When drawing out the cord and hoses from the left side, rotate the
water supply hose counterclockwise, and insert it to the cutout.
When extending the cord and
hose from the right
Bottom of the unit
When extending the cord and
hose from the left
Front panel
of the main unit
Front panel
of the main unit
3
Attach the suction cup on the bottom surface of the main unit.
Suction cup
(supplied accessory)
z Screw it in until it
stops lightly.
4
Fix the main unit on the installation surface using the suction cup.
(to prevent overturning)
30 mm
Main unit
Mounting plate (supplied accessory)
z Wipe o dirt and moisture on the installation
position suciently.
z If the suction cup cannot be directly
attached, remove the suction cup mount
of the mounting plate, and attach it on the
installation surface. Then, attach the suction
cup on the mounting plate.
z When moving the product for maintenance, etc., incline the main unit, insert a chopstick or
similar item into the end of the suction cup, and remove the suction cup.
Installation 4
Install the Alkaline Ionizer
Gasket
7
6
5
8
9
To Next Page
Loading...
