7
Touchscreen
<Only for model with touchscreen>
You can use the touchscreen function to perform the same operation as the touch pad and mouse. Touch the screen surface
with the stylus (included).
To right-click
1 Click on the notification area.
changes to .
2 Click the object you want to right-click.
returns to .
NOTE
Do not touch the screen by hand or other object when you input using the stylus (included). Otherwise you may not be
able to input correctly.
You need to make the following setting for each user.
A Click [start] - [All Programs] - [Fujitsu Touch Panel (USB)] - [Touch Panel Configuration].
B Select the settings, and then click [OK].
Do not add a check mark to [Delete Cursor] since the display may be distorted.
If you add a check mark for [Use] in [Hold [Ctrl] key down + Touch the screen] of [Touch Panel Configuration], touching
the screen may always be recognized as a right-click. To return to the normal operation, press
Ctrl
on the keyboard.
The touchscreen function does not work in the Setup Utility, in the full screen of [Command Prompt].
1 Run [Touch Screen Calibration Utility].
Click [start] - [All programs] - [Fujitsu Touch Panel (USB)] - [Touch Screen Calibration Utility].
2 Using the stylus, touch each of the 12 “+” target marks one by one until it blinks, and then
press
Enter
.
3 Press
Enter
.
NOTE
Return the rotated display to [0 degree] ( page 14) before the touchscreen calibration.
Perform the touchscreen calibration for each user.
Touchscreen Calibration
To Next Page
Loading...
