Panasonic CF-19 series - Security Menu

92
Setup Utility
Boot Prompt Configuration Underlined items are the factory presets.
Security Menu
Setup Utility Prompt
• When [Setup Utility Prompt] is set to [Disabled], the message “Press F2 for Setup / F12 for LAN”
is not displayed on [Panasonic] boot screen. However, F2 and F12 will work even if the message
is not displayed.
Disabled
Enabled
Password on boot Disabled
Enabled
Set Supervisor Password Enter the sub-menu.
Hard Disk Lock
• Can be changed only when [Set Supervisor Password] is set.
Disabled
Enabled
User Password Protection Protected
No Protection
Set User Password
• Can be changed only when [Set Supervisor Password] is set.
Enter the sub-menu.
XEmbedded Security(TPM)
• Only for model that supports TPM
• For information on TPM, refer to the Installation Manual of “Trusted Platform Module (TPM)”.
Click [start] - [Run], enter “c:\util\drivers\tpm\readme.pdf”, and click [OK].
Enter the sub-menu.
XFingerprint Security
• Only for model with Fingerprint Reader
Enter the sub-menu.
XAMT Configuration Enter the sub-menu.