62
Camera
Take Photo
You can record the camera image as a picture.
1 Adjust the direction of camera, zoom (below), picture quality ( page 64), etc.
2 Click or click [Photos] - [Take photo].
You can assign the Snap function to the Tablet Button.
( page 67 “Assigning the Snap/Zoom In/Light Functions to the Tablet Button”)
When you specify the destination to save and the file name for the photo you about to take, click [Photos] -
[Name and Take photo]. If they are not specified, pictures are saved in the folder identified in “Changing the
Settings for Taking Pictures” ( page 64) and are assigned a temporary file name based on the date and time
taken.
NOTE
You can see taken pictures when opening this folder using Windows Explorer.
When the distance between the camera and subject is less than 60 cm {24″
}, the subject focus may be out of focus
due to the limitations of the camera.
Camera Light On
To turn on the light of the camera.
1 Click or click [Control] - [Camera Light] - [ON].
You can assign the Light function to the Tablet Button.
( page 67 “Assigning the Snap/Zoom In/Light Functions to the Tablet Button”)
The light goes off automatically after a certain period of time. Click [Control] - [Camera Light] - [Settings] to set
your preferred lighting duration.
Camera Light Off
To turn off the light of the camera.
1 Click or click [Control] - [Camera Light] - [OFF].
Zoom In
To turn on the light of the camera.
1 Click or click [Control] - [Zoom] and select [x 1.0], [x 1.5], [x 2.0], [x 2.5], or [x 3.0].
To Next Page
Loading...
